The post is the fence
Boards weather, vinyl washes, hinges get oiled. The part of a fence that decides whether it is straight in ten years is the part you never see. Here is why every Kodiak fence rides on 2-3/8″ galvanized steel driven 42 inches or more into the ground, below the Wisconsin frost line, with no concrete.
Every Kodiak fence stands on 2-3/8″ galvanized steel posts driven 42 inches or more into undisturbed soil, below the Northeast Wisconsin frost line. The posts are driven, not set: no concrete, no footings, no cure time. Frost has nothing wide to grab and lift, steel can't rot at the ground line, and the gate hangs the same day.
Watch what the frost does to each one
Kodiak: a steel post, driven
A hydraulic post driver pushes a 2-3/8″ galvanized steel post 42″ or more into undisturbed soil, below the frost line. No hole, no concrete, no cure time.
The usual way: a wood post, set shallow
A wood post in a concrete collar, set above the frost line. On install day it looks every bit as straight.
Winter: the ground freezes from the top down
Water in the soil freezes, expands and pushes up on anything it has hold of. A wide collar is the easiest grip there is: the shallow post lifts and its fence racks. The steel post is held by solid ground below the frost.
Spring thaw: one post is still plumb
The shallow post never quite settles back. It leans over a gap under the collar and climbs again next winter. The driven steel post is exactly where it was put.
Three decisions, most of the lifespan
A wood post is wet at the ground line for half the year, and that is where it rots and where it snaps. Galvanized steel doesn't rot, doesn't wick water, and doesn't lose strength as it ages.
Northeast Wisconsin ground freezes deep and lifts whatever it grips. A post driven below that frozen layer is held by solid ground, with no footing for the frost to grab and lift.
A gate is a lever hanging off one post. Gate and corner posts take the most load, so they get heavier steel, driven deeper than the line posts between them.
It's almost never the boards
When a fence in Green Bay leans, waves or drags, the panels are usually fine. Something moved underneath them. Four things do most of that moving in Northeast Wisconsin, and all four are decided on install day.
Water in the soil freezes, expands, and pushes up on anything it has hold of. A shallow post climbs a little each winter and never quite settles back. By spring three, the line waves.
Wood posts fail where they meet the ground, not at the bottom. Soil, mulch and snow keep that band damp, and the post loses its strength exactly where the wind load is highest.
A six-foot privacy fence is a sail. Open lots in Suamico, Howard and along the lakeshore take sustained wind that works a loose post back and forth until the hole opens up.
Every swing of a gate pries on its post. If that post was set like a line post, the latch stops lining up first, then the gate drags, then the post leans for good.
The long version, with soil types and depth numbers, is in How deep should fence posts go in Wisconsin? and Frost heave and fence posts.
The Kodiak post, by the numbers
Same post whether the fence above it is cedar, vinyl, chain link or ornamental aluminum. On a vinyl fence the steel stands inside the vinyl post sleeve, so the fence looks like vinyl and holds like steel.
A wood post versus ours
Treated 4×4 or 6×6, usually 24–36″ deep
Rots at the ground line in 8–15 years
Twists and checks as it dries
Concrete collar traps water against the wood
Gate posts often the same size as line posts
2-3/8″ galvanized steel, 42″ or more deep
No rot, no wicking, no soft spot at grade
Stays straight; the panel never racks around it
Driven into undisturbed soil: no footing for frost to grab
Plumb and ready for the gate the same day, nothing to cure
Gate and corner posts heavier and deeper
Have an older fence with wood posts that has started to lean? We reset posts on fences we didn't build, on the same 2-3/8″ steel, and this guide walks through when a repair is enough.
What you'll notice, and what you won't
Walk the line after the thaw. The posts that moved on a shallow fence show up now. Yours shouldn't, and the gates should still latch where they did in October.
Wood boards may want a re-stain and vinyl wants a wash. The skeleton underneath hasn't changed, which is the whole point.
A storm-snapped board or a worn hinge is a quick fix on a fence whose posts are still plumb. On a fence with rotted posts, that same repair becomes a rebuild.
The part that is yours is small: keep water moving away from the fence line and keep snow piles off the panels. The care guide has the whole seasonal list.
Asked at the walkthrough
How deep are the posts on my fence?
Forty-two inches or more below grade, driven below the frost line. The professional range in Wisconsin is 36 to 48 inches depending on fence height, soil and gate load; we drive every post to the deep end of it so it bottoms out below the frost line.
Do you drive the posts in, or dig and set them?
We drive them. A hydraulic post driver pushes each 2-3/8″ galvanized steel post 42 inches or more into undisturbed soil, below the frost line. No hole is dug and no concrete is poured, so there is no loosened soil to settle, no footing for frost to grab, and no cure time: the gate hangs the same day. In our clay-heavy, freeze-thaw ground that is what keeps a line straight for decades.
Why can't I see the steel?
On a vinyl fence the steel post stands inside the vinyl post sleeve, so what you see is the clean white or tan post with galvanized steel doing the work inside it. On wood fences the steel is boxed in or bracketed behind the boards. Chain link and aluminum show the post itself.
Won't the post heave without concrete around it?
A driven post heaves less, not more. Frost lifts what it can grip, and a wide concrete collar is the easiest grip there is. A slim steel post driven below the frost line is held by undisturbed soil along its whole length, with nothing wide for the frost to catch. Water that pools against a post is still the thing to watch: keep downspouts, sprinklers and grading moving water away from the fence line.
A gate on my fence started dragging. Is the post moving?
Usually not. The first thing to check is hinge hardware and the latch, which loosen long before a driven steel post does. Text us a photo and we'll tell you which it is, and if it is ours to fix, we fix it.
Know someone with a leaning fence?
Their posts are the problem, not their boards. Send them our way and they get the same steel under their fence that is under yours.