Yes, we build and hang fence gates in Ledgeview: walk gates sized for a mower, 10- to 12-foot double drive gates, cantilever gates and ornamental aluminum driveway gates, plus automatic swing and slide operators with keypads and remotes. Gate posts are heavier and driven deeper, below the frost line, because a gate sags when its post moves. We can often automate a gate you already have if it's square and the posts are solid. Ledgeview is about 15 minutes south of our Green Bay shop.
- Walk gates
- About 4 ft wide
- Drive gates
- 10–12 ft double
- Openers
- Swing & slide operators
- Gate posts
- Larger, deeper, below frost
Gates & Openers in Ledgeview
Gates that clear a rising grade
On a Ledgeview slope, a gate that swings uphill hits the ground halfway open. We set the hinge side and swing direction so each leaf opens toward falling ground, and for wide openings on a slope a sliding cantilever gate avoids the swing problem entirely.
Automatic gates on sloped driveways
Driveways climbing the ledge make swing operators work harder and leave little room for a leaf to clear the pavement. A slide operator on a cantilever gate moves across the slope instead of up it, with no ground track for ice to jam. Keypads, remotes and an intercom can all run from the same operator.
Meltwater at the low point
On a hillside lot, snowmelt runs to the lowest spot and refreezes overnight — and a gate placed there can freeze to the ground by morning. We look at where water flows before setting the gate, put it on the higher side of the run when the yard allows, and hang it on posts driven below the frost line.
Gates that still latch in February
The post, not the gate
A gate is a lever hanging off its post. Frost heave or a shallow post lets it lean until the latch stops lining up — so our gate posts are heavier and driven deeper, below the frost line.
No ground track to freeze
For wide chain link openings, a cantilever gate slides clear without a track at grade that snow and ice can jam.
Cold-weather operators
Operators, hinges and latches specced for below-zero mornings — an automatic gate that freezes shut in January is worse than no operator at all.
Every gate job in Ledgeview starts with a free written quote, so you have a firm number before any work starts. Everything about gates & openers →
More fence services in Ledgeview
Gates & Openers: common questions
Which way should a gate swing on a sloped Ledgeview yard?
Toward the downhill side, whenever the layout allows. A gate that swings uphill hits the grade before it fully opens. On Ledgeview slopes we choose the hinge side and swing direction for each gate, and for wide openings a cantilever gate slides clear without swinging at all.
Can you automate a gate on a sloped driveway in Ledgeview?
Usually, yes. On sloped Ledgeview driveways a slide operator on a cantilever gate is often the better fit, because it travels across the slope with no ground track to freeze. Swing operators work where the leaves can clear the grade, and both take keypads, remotes and intercoms.
Why does my Ledgeview gate freeze shut?
Usually because it sits at a low point where snowmelt collects and refreezes, or because a heaved post has dropped the gate onto the ground. On Ledgeview hillside lots, moving the gate to higher ground or resetting its post below the frost line typically ends the problem.
Gates & Openers nearby: Green Bay · De Pere · Bellevue · Allouez · Ashwaubenon · Howard · Suamico · Hobart · Pulaski
2-3/8″ galvanized posts driven below the frost line, so nothing rots or heaves.
We pull the municipal permit and call Diggers Hotline on every job.
A free on-site measure, a firm number, no surprise add-ons later.
You deal with the people who build it, start to walkthrough.
Get a free gate quote in Ledgeview, WI
Free on-site estimates across Green Bay & Northeast Wisconsin. No pressure, just a clear written quote.